Exam Details

  • Exam Code
    :201-450
  • Exam Name
    :LPIC-2 - Exam 201 - version 4.5
  • Certification
    :LPI Certifications
  • Vendor
    :Lpi
  • Total Questions
    :161 Q&As
  • Last Updated
    :Mar 29, 2025

Lpi LPI Certifications 201-450 Questions & Answers

  • Question 71:

    A regular user, joe, has just run:

    ./configure andand make andand make install

    to build and install a program. However, the installation fails. What could be done to install the program? (Choose TWO correct answers.)

    A. Install the binaries manually with suinstall.

    B. Run make install with root privileges.

    C. Do not run ./configure in order to maintain the default configuration for correct installation.

    D. Rerun ./configure with a --prefix option where the user has permissions to write.

    E. Run make install_local to install into /usr/local/.

  • Question 72:

    Which of the following commands can be used to list IPv4 addresses and MAC addresses for IP devices that the system has seen on the local network?

    A. arp

    B. ifconfig

    C. ipadm

    D. iwlist

  • Question 73:

    Under which of the following circumstances would the command ping output the string (DUP!)?

    A. When the ICMP packets are send to a broadcast address and multiple hosts respond.

    B. When the host being sent ICMP packets is on a different network.

    C. When the router responds to the ICMP packet in addition to the host receiving the ICMP packets.

    D. When the host sending the ICMP packet is the same host as the one receiving the ICMP packets.

  • Question 74:

    Which of the following filter keywords for tcpdump specify the transfer direction for network packets? (Choose TWO correct answers.)

    A. source

    B. src

    C. dest

    D. src or dst

    E. both

  • Question 75:

    Which /etc/hosts.allow entries will permit access to sshd for users from the 192.168.1.0/24 subnet? (Choose TWO correct answers.)

    A. sshd : 192.168.1.

    B. sshd : 192.168.1

    C. sshd : 192.168.1.0 netmask 255.255.255.0

    D. sshd : 192.168.1.0/255.255.255.0

    E. sshd : 192.168.1.0

  • Question 76:

    The following is an excerpt from the output of tcpdump -nli eth1:

    13:03:17.277327 IP 192.168.123.5.1065 > 192.168.5.112.21: Flags [.], ack 1 (truncated)

    13:03:17.598624 IP 192.168.5.112.21 > 192.168.123.5.1065: Flags [P.], seq (truncated)

    Which network service or protocol was used?

    A. FTP

    B. HTTP

    C. SSH

    D. DNS

    E. DHCP

  • Question 77:

    What should be done to ensure a client machine uses the recursive nameserver running on the IP address 192.168.0.1? (Choose TWO correct answers.)

    A. Add nameserver 192.168.0.1 to /etc/resolv.conf.

    B. Run route add nameserver 192.168.0.1.

    C. Run ifconfig eth0 nameserver 192.168.0.1.

    D. Ensure that the dns service is listed in the hosts entry in the /etc/nsswitch.conf file.

    E. Run bind add nameserver 192.168.0.1.

  • Question 78:

    Which command can be used to scan a specified network looking for IP addresses that appear to be in use?

    A. nmap

    B. tcpdump

    C. ip

    D. netscan

    E. hostdiscover

  • Question 79:

    Considering the following kernel IP routing table below, which of the following commands must be used to remove the route to the network 10.10.1.0/24? (Select TWO answers) Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface

    203.0.113.162 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0

    172.16.87.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0

    192.168.246.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1

    10.10.1.0 192.168.246.11 255.255.255.0 UG 0 0 0 eth1

    127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo

    0.0.0.0 203.0.113.162 0.0.0.0 UG 0 0 0 ppp0

    A. ip net delete 10.10.1.0/24

    B. route del 10.10.1.0/24

    C. route del -net 10.10.1.0/24

    D. route del 10.10.1.0/24 gw 192.168.246.11

    E. ip route delete 10.10.1.0/24

  • Question 80:

    What is incorrect about these entries in /etc/hosts which could be causing host name lookup problems with host2?

    host1 192.168.1.12

    host2 192.168.1.12

    A. Two host names are using the same IP address.

    B. The server doing the query is on a different subnet.

    C. The fields are out of order.

    D. host2 is not a fully qualified domain name.

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Lpi exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 201-450 exam preparations and Lpi certification application, do not hesitate to visit our Vcedump.com to find your solutions here.