F5 F5 Certifications 201 Questions & Answers

• Question 161:

  A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it. Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B. What should the BIG-IP Administrator do to ensure the new VLAN is configured on each Cluster Member?

  A. Configure the new VLAN manually on Cluster Member B.

  B. Reset the Device Trust of the BIG-IP Cluster on either Cluster Member.

  C. Configure a Default Route for the new VLAN on Cluster Member A.

  D. Enable the Interface that is attached to the new VLAN on Cluster Member A.

  Correct Answer: A

• Question 162:

  Refer to the exhibit.

  

  A BIG-IP Administrator configures a Virtual Server to handle HTTPS traffic. Users report that the application is NOT working. Which actional configuration is regard to resolve this issue?

  A. Configure SSL Profile (Client)

  B. Configure Protocol Profile (Server)

  C. Configure Service Profile HTTP

  D. Configure SSL Profile (Server)

  Correct Answer: A

• Question 163:

  A BIG-IP Administrator is checking the BIG-IP device for known vulnerabilities. What should the 8IG-IP Administrator upload to BIG-IP iHealth for further analysis?

  A. QKView

  B. EUD

  C. UCS

  D. tcpdump

  Correct Answer: A

• Question 164:

  To increase available bandwidth of an existing Trunk, the BIG-IP Administrator is adding additional interfaces. Which command should the BIG-IP Administrator run from within bosh shell?

  A. tmsh create /net trunk trunk_A interfaces add {1.3.1.4}

  B. tmsh create/sys trunk trunk_A interfaces add {1.3.1.4}

  C. tmsh modify/sys trunk trunk^A interfaces add {1.3.1.4}

  D. tmsh modify /net trunk trunk_A interfaces add {1.3.1.4}

  Correct Answer: D

• Question 165:

  Which statement is true regarding failover?

  A. Hardware failover is disabled by default.

  B. Hardware failover can be used in conjunction with network failover.

  C. If the hardware failover cable is disconnected, both BIGIP devices will always assume the active role.

  D. By default, hardware fail over detects voltage across the failover cable and monitors traffic across the internal VLAN.

  Correct Answer: B

• Question 166:

  Refer to the exhibit.

  

  A user notifies the BIG-IP Administrator that http://remote company.com is NOT accessible. Remote access to company resources must be encrypted.

  What should the BIG-IP Administrator do to fix the issue?

  A. Change the Listening Port on remote.company.com_vs to Port 80

  B. Add a Pool to the Virtual Server remote.company.com_VS

  C. Add an iRule to remote.company.com_vs to redirect Traffic to HTTPS

  D. Change the Type of the Virtual Server remote.company.com_vs to Forwarding

  Correct Answer: C

  Explanation: Requiring all traffic to be HTTPS access requires HTTP requests to be redirected directly to HTTPS.

• Question 167:

  Assume a virtual server has a ServerSSL profile. What SSL certificates are required on the BIG-IP?

  A. No SSL certificates are required on the BIG-IP.

  B. The BIG-IP's SSL certificates must only exist.

  C. The BIG-IP's SSL certificates must be issued from a certificate authority.

  D. The BIG-IP's SSL certificates must be created within the company hosting the BIG-IPs.

  Correct Answer: A

• Question 168:

  Refer to the exhibit.

  

  According to the shown Configuration Utility stings What is the setting of the User Directory configuration under the Authentication submenu?

  A. Local

  B. Managed

  C. Remote-TACACS+

  D. Default system configuration

  Correct Answer: C

• Question 169:

  Users are unable to reach an application. The BIG-IP Administrator checks the Configuration Utility and observes that the Virtual Server has a red diamond in front of the status. What is causing this issue?

  A. All pool members are down.

  B. The Virtual Server is receiving HTTPS traffic over HTTP virtual.

  C. The Virtual Server is disabled.

  D. All pool members have been disabled.

  Correct Answer: A

• Question 170:

  Under what condition must an appliance license be reactivated?

  A. Licenses only have to be reactivated for RMAs no other situations.

  B. Licenses generally have to be reactivated during system software upgrades.

  C. Licenses only have to be reactivated when new features are added (IPv6, Routing Modules, etc) no other situations.

  D. Never. Licenses are permanent for the platform regardless the version of software installed.

  Correct Answer: B