A network architect is designing a VMware SD-WAN architect for customer using VMware hosted VCO and VCGs, white VCEs will be deployed at the customer's branches and data centers. The network architect would like to achieve control plane redundancy. Which action, if any, should be taken to meet this goal?
A. Multiple VCGs are automatically assigned to every VCE and control plane on VCUs is always enabled, so control plane redundancy has been taken care of already
B. Multiple VCFs at data centers can be contoured to function as route reflectors to achieve control plane redundancy.
C. VCGs automatically assigned to a VCF. do not participate in control plane At least two dedicated Controllers should be manually assigned for each VCGs to achieve control plane redundancy.
D. VCGs automatically assigned to a VCE do not participate in control plane At least two dedicated Controllers should be manually assigned for the customer to achieve control plane redundancy
A customer is using hypervisor to install VMware Partner Gateways. Which two hypervisors may be used? (Choose two.)
A. Hyper-V
B. Kubermetes
C. XenServer
D. KVM
E. ESXi
What Is a typical use case for the deployment of a VMware SU-WAN Partner Gateway?
A. Provide connectivity between multiple enterprise customers over private circuits
B. Get improved flow analytics for all traffic in the SD-WAN network
C. Interconnect branches/remote sites of a single enterprise customer to the internet
D. Provide mite transport m a service provider backbone tor interconnecting a global customer SD- WAN branches.
What are three key benefits of VMware SD-WAN? (Choose three )
A. Provision Edges in minutes
B. Automated configuration of cloud resources
C. Remove requirement of Edge devices
D. Gain visibility across any link
E. Layer 2 VPNs between sites
F. Reduce the burden on MPLS
Which characteristic of Software Defined Networks (SDN) is also true for VMware SD-WAN
A. VMware SD-WAN requires specialized hardware to run its software
B. VMware SD -WAN provides distributed management and control plane
C. VMware SU-WAN allows customers to program the forwarding plane
D. VMware SD-WAN provides separation of management control plane, and the data plane.
An enterprise has deployed a VMware SD-WAN solution with Edges in many different located to different
Partner Gateways.
Which design makes it possible to have dynamic branch to branch VPN tunnels between any two Edges?
A. Dedicated at least one Gateway as a Controller, and few initial data plane packets will travers the Controller before dynamic tunnel is established between the two branches.
B. Add Controller role to each Partner Gateway.
C. Configure each partner Gateway as a Controller.
D. Dedicate at least one Gateway as a Controller, and no data plan packets will traverse the Controller before dynamic tunnel is established between the two branches.
Company A has recently acquired Company B and needs to establish network connectivity. Company A has only Cisco for firewalls and VPN. Company B is using VMware SD-WAN. Which VMware SD-WAN Cloud VPN solution should an administrator configure to establish connectivity?
A. Branch to Non VMware SD-WAN Site.
B. Branch to SD-WAN Hub
C. Branch to Main Office VPN
D. Branch to Branch VPN
A customer is migrating a branch site with a VMware SD-WAN Edge coexisting with the CE. The Edge will be connected to internet link directly while connecting to the CE via a Layer 3 LAN switch. MPLS underlay is the preferred path for communication from this site to branch sites that have no VMware SD-WAN Edges. Communication from this site to branch sites that have VMware SD-WAN Edges should go through overlay.
A. Use BGP as the rout.ng protocol on UK Edge and flag its BGP neighbor to the Layer 3 LAN switch as Uplink.
B. Use BGP as the routing protocol on the Edge and filter prefixes from CE using Uplink Community
C. Use BGP as the routing protocol on the Edge and flag its HGP neighbor to PE as Uplink.
D. Use BGP as the routine, protocol on the Edge and flag its BGP neighbor to GE as Uplink.
An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.
A. Configure a NAT hand off rule at the VMware SD WAN gateway assigned to these new blanches, translating the new branch subnets into a new nan-overlapping subnet
B. Configure a LAN-side NAT rule at the branch device settings, translating its subnets into a new non-overlapping subnet
C. Configure a NAT firewall rule in each branch, translating its subnets into a new non-overlapping subnet
D. Configure a policy based NAT tor each branch translating its subnets Into a new non-overlapping subnet
A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their
existing provider (idp) for access to their Orchestrator account.
Which authentication protocol is supported?
A. OpenID Connect (OlDC)
B. LDAP
C. SAML 2.0
D. TACACS+
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only VMware exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 5V0-42.21 exam preparations and VMware certification application, do not hesitate to visit our Vcedump.com to find your solutions here.