If you modify the host initiator node name, then the array end connected to it need to reconfigure the starter.
A. True
B. False
FC-SAN and IP-SAN relatively which is wrong:
A. FC-SAN is limited transmission distance,IP-SAN theoretically unlimited.
B. FC-SAN easier than IP-SAN deployments.
C. FC-SAN disaster recovery hardware,high software costs,IP-SAN itself can achieve both local and remote disaster recovery and low cost.
D. FC-SAN to build fiber-optic network and HBA cards alone , IP-SAN can use existing IP networks.
If the host is a cluster of two nodes to the cluster configuration LUN mapping on the array, the following statement is correct:
A. When added to the cluster LUN, LUN needs were added to the node
B. When added to the cluster LUN, just give the host group is added LUN
C. When ISM configuration,corresponding to the two nodes belong to different hosts can host group
D. None of the above comments
Fibre Channel protocol transmission media may be used: (Choose three)
A. Copper
B. Multimode fiber optic cable
C. Single-mode fiber optic cable
D. SAS cables
iSCSI (Internet SCSI) the encapsulated SCSI commands and data transmission over TCP / IP protocol.
A. True
B. False
What level of alarm failure statistics include ISM: (Choose three)
A. Urgent
B. Important
C. General
D. Warning
ntfs file system supports a maximum partition size is 1TB.
A. True
B. False
When the storage array through the serial port login, the baud rate is set to:
A. 115200
B. 9600
C. 38400
D. None of the above comments
RAID6 argument about the correct yes: A. If there is no hot spare,RAID6 disk while a member does not cause damage to two RAID failure.
B. If there is no hot spare,RAID6 disk while a member does not cause damage to three RAID failure.
C. Since the introduction of the two parity disk RAID6,so check the performance led to the entire RAID group performance than the same number of RAID5 hard drive upgrade.
D. The above statement is not correct.
SuSE Linux 10 under Input # iscsiadm-m discovery-t st-p xxx.xxx.xxx.xxx, whose role is to:
A. Adding target device
B. Start the iSCSI Initiator
C. Landing target device
D. Add starter
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Huawei exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your HC-611 exam preparations and Huawei certification application, do not hesitate to visit our Vcedump.com to find your solutions here.