One week ago you performed a single file SnapRestore from a snapshot other than the most recent. You now notice that the storage appliance is now taking longer to perform snapshot deletions. Which one of the following reasons is the most likely cause of this problem?
A. Snapshots that existed after the one used for the single fileSnapRestore need to be manually deleted.
B. The SnapRestore schedule changed from weekly to hourly.
C. All of the snapshots created after you did the single fileSnapRestore were deleted, and reserved inodesfrom the snapshots still exist.
D. Before a snapshot can be deleted, the active maps across all snapshots need to be checked for active blocks related to the file you restored.
Which one of the following commands or procedures would you use to undo a SnapRestore reversion?
A. snap restore -r
B. snap revert-s
C. snap restore undovol
D. None of the above. You cannot undo aSnapRestore reversion.
You can unlicense the cluster feature only in mode with cluster:
A. normal, disabled
B. normal, enabled
C. takeover, disabled
D. takeover, enabled
Normally, before you split a SyncMirror volume, you ensure that both plexes are:
A. plexes, pools
B. online, operational
C. offline, operational
D. snapshots, contain the most recent snapshot
When you issue the snapmirror status command, to what does the "Lag" column refer?
A. The amount of time it takes for the baseline transfer to complete.
B. The difference between the current time and the last basic snapshot creation time on the destination for a transfer which completed successfully.
C. The difference between the current time and the last basic snapshot creation time on the source for a transfer which completed successfully.
D. The difference between the most recent snapshot and the last basic snapshot creation time on the source for a transfer which completed successfully.
Which MetroCluster configuration procedure is recommended for re-establishing a mirrored volume that was in a level-0 re synchronization state when it failed?
A. Rejoin the two volumes.
B. Re-create the synchronous mirror
C. Turn on power to the cluster node at the disaster site.
D. Determine which volumes are at the remote and disaster sites.
Five minutes ago, you performed a single file SnapRestore on a large NFS file. 40% of your NFS users are now complaining about getting "stale file handles" for the file. Which one of the following is the most likely cause of this problem, and the best procedure to correct it?
A. These users are on a different subnet from the others. Start troubleshooting by checking their subnet.
B. After a single fileSnapRestore, NFS users have to reboot their systems. Have them reboot their systems.
C. This might be due to an NFS storage appliance and client versionmis-match. Check to see that these users have the same version of the NFS client that existed at the time the snapshot was taken.
D. NFS users who try to access a reverted file without first reopening it might get a "stale file handle" error message. Have the users try to reopen the file and see if the problem is resolved.
A mirrored volume has a failed disk, but there are no available spares in the pool from which the degraded plex was built. Data ONTAP will:
A. Choose spare disks to reconstruct from the opposite pool
B. Warn you that there are no available spares from the proper pool
C. "Halt" after 24 hours if spare disks are not added to the proper pool
D. Stop all applications that are running
When you issue the snapmirror status command, to what does the "Lag" column refer?
A. The amount of time it takes for the baseline transfer to complete.
B. The difference between the current time and the last basic snapshot creation time on the destination for a transfer which completed successfully.
C. The difference between the current time and the last basic snapshot creation time on the source for a transfer which completed successfully.
D. The difference between the most recent snapshot and the last basic snapshot creation time on the source for a transfer which completed successfully.
The NearStore system is not the recommended secondary storage appliance for Open System SnapVault.
A. True
B. False
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only NetApp exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your NS0-163 exam preparations and NetApp certification application, do not hesitate to visit our Vcedump.com to find your solutions here.