NetApp NetApp Certifications NS0-504 Questions & Answers

• Question 331:

  Which command or procedure would you use to undo a volume SnapRestore operation?

  A. snap restore -r vol

  B. snap revert -s vol

  C. snap restore undo vol

  D. You cannot undo a SnapRestore operation at the volume level.

  Correct Answer: D

• Question 332:

  When Data ONTAP creates a weekly, nightly, or hourly snapshot, the value of n (as shown by the snap list command) is adjusted for all the weekly.n, nightly.n, or hourly.n Snapshot copies. The higher the value of n, the _________ the snapshot.

  A. older

  B. newer

  C. more important

  D. least important

  Correct Answer: A

• Question 333:

  A SnapVault secondary volume can contain up to ___ Snapshot copies for data protection.

  A. 125

  B. 251

  C. 255

  D. Depends on capacity and number of disk drives

  Correct Answer: B

• Question 334:

  Data ONTAP uses inodes in an active file system to reference ___________.

  A. qtrees

  B. disk blocks

  C. file segments

  D. Snapshot copies

  Correct Answer: B

• Question 335:

  Which command disables client access to Snapshot copies on a volume called flexvol1?

  A. cifs shares -change flexvol1 -nosnap

  B. snap access flexvol1 off

  C. vol options flexvol1 nosnapdir on

  D. vol options flexvol1 snapdir off

  E. vol options flexvol1 snapdir on

  Correct Answer: C

• Question 336:

  Physical Reallocation of a SnapMirror source volume increases the amount of data to transfer for the next SnapMirror update.

  A. True

  B. False

  Correct Answer: B

• Question 337:

  A snapshot is a frozen, read-only image of the entire Data ONTAP active file system that reflects the state of the ____________ at the time the snapshot was created.

  A. qtrees

  B. volume

  C. directory

  D. storage system

  Correct Answer: B

• Question 338:

  Which command is used to set the configuration of an Ethernet network interface?

  A. ifconfig

  B. ifstat

  C. netstat - i

  D. sysconfig - v

  Correct Answer: A

• Question 339:

  What are three true statements about physical reallocation of data added in ONTAP 7.3? (Choose three.)

  A. Use reallocate -p pathname to run the physical reallocate.

  B. Use aggr reallocate -p pathname to run the physical reallocate.

  C. Reinitialize any SnapMirror relationship for the new physical geometry.

  D. Volume Snapshots do not need to be deleted for the reallocate to run effectively.

  E. Dont run it on files, volumes, and LUNs that are in an aggregate created by a version of ONTAP earlier than 7.2.

  Correct Answer: ADE

• Question 340:

  Which set of commands should be used for troubleshooting Ethernet connectivity problems from the storage system console?

  A. ifstat, netdiag

  B. perfstat, tracert

  C. sysconfig - cr, sysstat

  D. dish shm_stats, sysstat

  Correct Answer: A