VMware VMware Certifications VCPC550 Questions & Answers

• Question 91:

  A customer needs to select an appropriate Path Selection Policy (PSP) for their storage array. There is no requirement for a preferred path. The policy should not select a new path unless the current one fails. Which PSP meets the requirement?

  A. Fixed

  B. Round Robin

  C. Most Recently Used

  D. Asymmetric Logical Unit Access

  Correct Answer: C

• Question 92:

  Which condition would prevent an administrator from unmounting a VMFS datastore?

  A. The datastore is being managed by Storage DRS.

  B. The datastore contains vCenter Server templates.

  C. The datastore is mounted by multiple hosts.

  D. The storage backing the datastore is detached.

  Correct Answer: A

• Question 93:

  An administrator needs to deploy several virtual machines. Storage contention between the virtual machines should be managed by the VMkernel. Some of the virtual machines will use MSCS and should be highly available across the ESXi 5.5 hosts. Which two storage options meet these requirements? (Choose two.)

  A. iSCSI

  B. NFS

  C. Fibre Channel

  D. VSAN

  Correct Answer: AC

• Question 94:

  Which feature requires an administrator using an RDM to configure it with virtual compatibility mode?

  A. vMotion

  B. Virtual Machine Snapshots

  C. High Availability

  D. N-port ID Virtualization

  Correct Answer: B

• Question 95:

  An administrator needs to create a two-node virtual machine cluster in a vSphere environment that uses a

  Fibre Channel SAN. The clustering software does not have a SCSI target or a SCSI command pass-

  through requirement.

  Which VMware storage type should the administrator use?

  A. Physical RDM

  B. VMFS

  C. Virtual RDM

  D. NFS

  Correct Answer: B

• Question 96:

  An administrator has configured multi-pathing using an FC array in an active-active configuration.

  What is the expected behavior of the host when a failed preferred path becomes available using the Fixed

  path selection policy for this array type?

  A. It automatically reverts to the preferred path.

  B. It continues using the current path until it is manually reverted.

  C. It resumes load balancing across all available paths.

  D. It reverts to the preferred path after the host has been restored and rebooted.

  Correct Answer: A

• Question 97:

  An administrator is planning a new vSphere deployment using shared storage. The solution must support:

  vMotion

  Storage vMotion

  Fault Tolerant virtual machines

  VAAI primitives

  RDM disks

  Which storage type will meet these requirements?

  A.

  CIFS

  B.

  iSCSI

  C.

  NFS

  D.

  VSAN

  Correct Answer: B

• Question 98:

  Which information can the administrator use to identify iSCSI nodes?

  A. MAC address

  B. IQN

  C. WWN

  D. LUN ID

  Correct Answer: B

• Question 99:

  A virtual machine is unable to communicate with another virtual machine. Both virtual machines are connected to the Production port group on the same virtual switch and are running on the same host. Which configuration is causing the inability of the virtual machines to communicate?

  A. LLDP was enabled instead of CDP for the vSphere Distributed Switch.

  B. Promiscuous Mode has been set to Allow on the Production port group.

  C. The Production port group is configured to use a secondary PVLAN.

  D. The speed and duplex settings for the virtual machine vmnics do NOT match.

  Correct Answer: C

• Question 100:

  A vSphere administrator needs to perform packet tracing from a Linux virtual machine. The virtual machine is attached to a standard virtual switch configured with several VLANs. Which approach could the administrator use to configure the network to capture all traffic from the Linux virtual machine?

  A. Configure the virtual switch with VLAN Trunking and specify each VLANs on the port group containing the virtual machine.

  B. Configure a distributed virtual switch with VLAN Trunking. Create a port group and configure it with promiscuous mode. Connect the virtual machine to that port group.

  C. Configure the port group containing the virtual machine for promiscuous mode. Set the port group to use VLAN 1.

  D. Configure a distributed virtual switch with VLAN Trunking. Connect the virtual machine to the switch and enable Port Mirroring on the port group containing the virtual machine.

  Correct Answer: B