A vSphere administrator has configured a virtual machine alarm to trigger a warning when the condition Snapshot Size exceeds 1GB.
Which action should the administrator configure on the alarm to automatically resolve the condition?
A. Delete Snapshot
B. Reset VM
C. Run a Command
D. Consolidate Snapshot
An administrator has created a Virtual Flash Read Cache and needs to add a total 2TB of capacity to the cache. The administrator has a total of six SSD disks to add, but is unable to add one of the disks.
What is a likely cause of the problem?
A. The SSD device size is less than 256GB.
B. The SSD device size is greater than 4TB.
C. The SSD device is a local disk.
D. The SSD device contains existing data.
An administrator is deploying vSphere using a NAS device as the shared storage system. The administrator has already created a VMkernel port, enabled the NFS client, and configured a mount point accessible to the hosts.
Which additional configuration is required before the datastore can be used to create virtual machines?
A. The ESXi hosts must have root access to the datastore.
B. The NAS must support NFS version 4.
C. Port binding must be configured on the VMkernel port.
D. The MTU on the VMkernel port must be set to 9000.
A vSphere administrator notices that hosts are not powering off when the total cluster load is low on a cluster configured with Dynamic Power Management.
What condition could cause this behavior?
A. The DRS migration threshold is set to the most conservative setting.
B. The DRS migration threshold is set to the most aggressive setting.
C. The DPM migration threshold is set to the most conservative setting.
D. The DPM migration threshold is set to the most aggressive setting..
A storage engineer determines there are problems with the iSCSI network. A vSphere administrator needs to gather performance metrics from a specific ESXi 5.x host to determine if the issue is causing high storage latency on the ESXi host.
Which tool should the vSphere administrator use to gather this data?
A. esxtop
B. vmkfstools
C. vmware-cmd
D. esxcli iscsi
An administrator is deploying vSphere 5.5. The administrator creates a vSphere Distributed Switch, then uses Auto Deploy to deploy several ESXi hosts. After the hosts are deployed, the administrator notices that LACP packets are not being sent between them.
Which condition would cause this issue to occur?
A. The LACP support settings do not exist in the Host Profile.
B. The LACP installation bundle is not included in the Image Profile.
C. LACP is not enabled on vCenter.
D. LACP has not been configured on the Auto Deploy server.
Why would a vSphere administrator configure resource shares for a virtual machine?
A. To prioritize access to a resource during contention
B. To guarantee access to a resource during contention
C. To prioritize access to a resource at all times
D. To guarantee access to a resource at all times
An administrator is installing ESXi 5.x to a local SAS drive. The installation stops on a purple screen and shows the error:
The system has found a problem on your machine and cannot continue. Could not populate the filesystem: Admission check failed
Which action should the administrator take to resolve this issue?
A. Upgrade the ESXi host to meet the minimum hardware requirement for installation.
B. Disable the network interface cards (NICs) to ensure that third-party drivers do not interfere with installation.
C. Enable hardware Virtualization Technology in the ESXi host BIOS.
D. Disable the Host Bus Adapters (HBA) to ensure the installation targets the local disk.
An administrator needs to deploy several virtual machines. Storage contention between the virtual machines should be managed by the VMkernel. Some of the virtual machines will use MSCS and should be highly available across the ESXi 5.5 hosts.
Which two storage options meet these requirements? (Choose two.)
A. iSCSI
B. NFS
C. Fibre Channel
D. VSAN
A vSphere administrator creates a new vSphere Distributed Switch. The administrator receives notice from the service desk that a cluster of vSphere hosts has disconnected from vCenter Server. This disconnect occurred immediately after the new switch was created. This vSphere Distributed Switch is the only distributed switch managed by vCenter Server. The virtual machines are still functional and the applications are still accessible by end users.
On the ESXi hosts, which step must the vSphere administrator take to allow vCenter Server to reconnect?
A. Use the Direct Console User Interface to reattach the management vmnic to the appropriate switch
B. Use the Direct Console User Interface to disable lockdown mode on each affected host
C. Use the ESXi Shell to restart the mgmt-vmware service on each affected host
D. Use the ESXi Shell to restart the vSphere Web Client service on each affected host
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only VMware exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your VCPC610 exam preparations and VMware certification application, do not hesitate to visit our Vcedump.com to find your solutions here.