Huawei Huawei Certifications H35-210 Questions & Answers

• Question 31:

  (single) In Ethernet, what address is used to distinguish different devices?

  A. LLC address

  B. MAC address

  C. IP address

  D. IPX address

  Correct Answer: B

• Question 32:

  (single) Is the following description correct? The traffic-table on the OLT can not only set the parameters of the traffic rate limit, but also support the setting of the priority policy.

  A. True

  B. False

  Correct Answer: A

• Question 33:

  (single) Is the following description correct? The MA5600T/MA5680T GPON Internet service simplification method optimizes the number of templates and complex configurations in the template mode, reducing user configuration workload and post-maintenance costs. The simplified mode currently only supports the GPON FTTH scenario. For the newly created GPON FTTH scenario and scenarios with low QoS requirements, the simplified mode can be used for service configuration.

  A. True

  B. False

  Correct Answer: A

• Question 34:

  (single) Which of the following commands is used to shut down the sybase primary server?

  A. shutdown SYS_MAIN

  B. shutdown SYS

  C. shutdown

  D. Shutdown

  Correct Answer: C

• Question 35:

  (single) PON hanging two-stage splitter, level 1 is 1:2, level 2 splitter is 1:16, what is the total split ratio?

  A. 1:2

  B. 1:16

  C. 1:18

  D. 1:32

  Correct Answer: D

• Question 36:

  (single)MUX vlan

  A. There are two types of ports: uplink port and service virtual port.

  B. A MUX VLAN can contain multiple uplink ports and multiple service virtual ports.

  C. Layer 2 interworking between different MUX VLANs

  D. The MUX VLAN is mainly used for cell access.

  Correct Answer: A

• Question 37:

  (single) How many Bytes does the EthernetII header (without the VLAN TAG tag) include?

  A. 18

  B. 14

  C. 22

  D. 32

  Correct Answer: B

• Question 38:

  (single) Is the following description correct? The MAC address consists of 48 bits, usually expressed in 12digit hexadecimal. The first 6 hexadecimal digits are uniformly distributed by the IEEE to determine the uniqueness of the vendor. The last 6 hexadecimal digits are managed by each vendor.

  A. True

  B. False

  Correct Answer: A

• Question 39:

  (multiple) What checks need to be performed after the hardware installation is completed?

  A. The cabinet is clean and has no deformation, paint falling off and rust.

  B. There is no debris in the cabinet and the screws should be tightened. The components inside the cabinet should not rust. Air filter installed

  C. The power cable is connected correctly, and the cabinet should be grounded.

  D. The cabinet door and the side baffle are connected to the main body by a ground wire, and the cabinet door switch is smooth.

  Correct Answer: ABCD

• Question 40:

  (single) In the GPON network, which of the following statements is incorrect?

  A. Each T-CONT consists of one or more GEM Ports, each carrying a traffic flow. A T-CONT can carry data streams of one or more types of services.

  B. Each GEM Port is identified by a unique Port-ID. The range of the Port-ID is 0 to 4095, and is globally allocated by the OLT. That is, each ONU/ONT under the OLT cannot use the GEM with duplicate Port-ID. Port.

  C. The GEM Port identifies the service virtual channel between the OLT and the ONU/ONT, that is, the channel that carries the service flow, similar to the VPI/VCI identifier in the ATM virtual link.

  D. Supports up to 32 ONUs/ONTs per GPON port

  Correct Answer: D