HP HP Certifications HPE6-A75 Questions & Answers

• Question 31:

  Refer to the exhibit.

  

  An employee connects a corporate laptop to the network and authenticates for the first time using EAPTLS. Based on the Enforcement Policy configuration shown, which Enforcement Profile wilt be sent?

  A. Deny Access Profile

  B. Onboard Post-Provisioning - Aruba

  C. Onboard Device Repository

  D. Onboard Pre-Provisioning - Aruba

  Correct Answer: D

• Question 32:

  A company has AOS-Switches, Aruba ClearPass, and Aruba Airwave. A network administrator needs to set up a new switch with the same settings found on other switches in the company. Which action rs likely to be the most useful to perform the task?

  A. Access the Network Device view on ClearPass.

  B. Use the configuration audit tool on AirWave.

  C. View the current running config on each switch.

  D. View usage patterns on the switches on AirWave.

  Correct Answer: A

• Question 33:

  Refer to the exhibit.

  

  A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?

  A. The standby uses its own port in the link aggregation to forward the fabric.

  B. The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.

  C. The standby uses the typical load sharing algorithm, and it might select either its port or the commander's port.

  D. The standby selects the port on the designated forwarder for the aggregation.

  Correct Answer: A

• Question 34:

  Refer to the exhibit.

  

  An Enforcement Profile has been created in the Policy Manager as shown. Which action will ClearPass take based on this Enforcement Profile?

  A. ClearPass will count down 600 seconds and send a RADIUS CoA message to the user to end the user's session after this time is up.

  B. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the NAD and the NAD will end the user's session after 600 seconds.

  C. ClearPass will count down 600 seconds and send a RADIUS CoA message to the NAD to end the user's session after this time is up.

  D. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Request packet to the NAD and the NAD will end the user's session after 600 seconds.

  E. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the User and the user's session will be terminated after 600 seconds.

  Correct Answer: B

• Question 35:

  Refer to the exhibit.

  

  A. mike

  B. We can't know this from the screenshot above.

  C. Employee

  D. john

  Correct Answer: B

• Question 36:

  An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).

  Which mechanism will then attempt to restore the previous working configuration on the managed controller?

  A. disaster recovery

  B. auto-rollback

  C. restore config

  D. bulk configuration

  Correct Answer: B

• Question 37:

  Refer to the exhibit.

  

  A network administrator sets up 802.1X authentication to a RADIUS server on an AOS- Switch. The

  RADIUS server and user devices are both set up to use REAP MSCHAPv2. The administrator tests the authentication and sees the output shown in the exhibit. Which issue could cause this output?

  A. The RADIUS shared secret does not match on the switch and the server.

  B. The administrator entered the wrong password for the test account.

  C. The switch does not have a certificate tor port-access installed on the switch.

  D. The switch port is set for user mode 801. IX. but the RADIUS server is set for port mode.

  Correct Answer: A

• Question 38:

  An administrator deploys an AP at a branch office. The branch office has a private WAN circuit that provides connectivity to a corporate office controller. An Ethernet port on the AP is connected to a network storage device that contains sensitive information. The administrator is concerned about sending this traffic in clear-text across the private WAN circuit.

  What can the administrator do to prevent this problem?

  A. Redirect the wired port traffic to an AP-to-controller GRE tunnel.

  B. Convert the campus AP into a RAP.

  C. Enable AP encryption for wired ports.

  D. Enable IPSec encryption on the AP's wired ports.

  Correct Answer: D

• Question 39:

  Which statement is true about the Endpoint Profiler? (Select two.)

  A. The Endpoint Profiler uses DHCP fingerprinting for device categorization.

  B. Data obtained from the Endpoint Profiler can be used in Enforcement Policy.

  C. Endpoint Profiler requires a profiling license.

  D. The Endpoint Profiler requires the Onboard license to be enabled.

  E. The Endpoint Profiler can only categorize laptops and desktops.

  Correct Answer: AB

• Question 40:

  An administrator configures the MultiZone feature for a company network, where a mobility cluster is the primary zone and a standalone controller in the company's DMZ represents a secondary data zone. The administrator configures two AP Groups and respective VAPs for the zones on the Mobility Master (MM) in the primary zone. When the APs boot up and establish connections to both zones, the administrator notices that no data connections are established to the data zone.

  What must the administrator do to fix this problem?

  A. Configure the same AP Groups and VAPs on the standalone controller, and associate the MultiZone APs to both groups.

  B. Configure the same AP Group in the data zone as it is in the primary zone, and configure the VAPs in the data zone.

  C. Have the MultiZone APs initially boot from the standalone controller in the data zone.

  D. Create different AP groups and VAPs on the Mobility Master and standalone controllers, and associate the MultiZone APs to both groups.

  Correct Answer: D