Juniper Juniper Certifications JN0-682 Questions & Answers

• Question 81:

  Referring to the exhibit, you must advertise the Io0.12 interface as a type-5 route.

  Which configuration parameter would be used to accomplish this task?

  

  A. Configure auto-export under the routing instance.

  B. Configure a vrf-export policy to advertise the interface route under the routing instance.

  C. Configure an export policy to advertise the interface route under protocols evpn.

  D. Configure vrf-table-label under the routing instance.

  Correct Answer: C

• Question 82:

  Referring to the exhibit, what would cause the problem on VCP 0/50?

  

  A. The port is missing the interface hardware

  B. The remote side is not configured as a VCP

  C. The VCP has been disabled through configuration

  D. VCP 0/50 is configured as a network port.

  Correct Answer: B

• Question 83:

  Referring to the exhibit,

  

  which two statements are correct? (Choose two.)

  A. There are two tunnels to the remote endpoint.

  B. The irb. 0 interface is the remote tunnel endpoint interface.

  C. The source tunnel IP address is 192.168.100.11.

  D. There is one tunnel to the remote endpoint.

  Correct Answer: CD

• Question 84:

  Which EVPN route type would be used in DCI situation in which the IP subnets between data center are complete unique?

  A. Type 4

  B. Type 3

  C. Type 2

  D. Type 5

  Correct Answer: D

• Question 85:

  You are deploying a VXLAN using signaling overlay network in your new data center. You are able to establish your MP BGP peering session and see your EVPN routes, but traffic will not traverse the VXLAN using signaling overlay network.

  What is a solution to this problem?

  A. Enable the mtu-discovery feature on the MP peering sessions between VXLAN ANs EVPN signaling peers.

  B. Increase the protocol MTU on all devices participating in VXLAN using EVPN signaling

  C. Increase the MTU on the logical VTEP source interface of all devices participating in VXLAN using EVPN signaling.

  D. Increase the physical MTU on all ports on all devices participating in VXLAN using EVPN signaling.

  Correct Answer: D

• Question 86:

  Which two statements are correct about VXLAN domains? (Choose two.)

  A. With Layer 2 traffic, the VLAN ID is discarded before the packet is sent.

  B. With Layer 3 traffic, the VLAN ID is discarded before the packet is sent.

  C. With Layer 2 traffic, the VLAN ID is transmitted within the packet.

  D. With Layer 3 traffic, the VLAN ID is transmitted within the packet.

  Correct Answer: AB

• Question 87:

  You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.

  

  Why is the BGP session failing to establish?

  A. The route-distinguisher value on the local PE is incorrect

  B. There is no route for 192.168.5.5 an VPN net 0.

  C. There is no route for 192.168.5.5. in inet 3.

  D. The vrf-table abel value is not configured in the remote PE.

  Correct Answer: C

• Question 88:

  Which IP fabric underlay protocol provides the highest degree of scalability?

  A. IS-IS

  B. RIP

  C. EBGP

  D. OSPF

  Correct Answer: C

• Question 89:

  You are asked to deploy 20 QFX Series devices using ZTP Each QFX5 100 requires FTP server. In this scenario, which two component must you configure on the DHCP Server? (Choose two.)

  A. The MAC address of the FTP server

  B. The IP address of the FTP server

  C. The MAC address of each QFX5100

  D. The MAC address of each FTP QFX5100

  Correct Answer: AB

• Question 90:

  Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down. Referring to the exhibit, which statement is correct?

  

  A. Type-1 routes for each VM will expire one at a time.

  B. Type-1 routes for all VMs in the site will expire all at once.

  C. Type-1 routes for all VMs in the site will be withdrawn all at once.

  D. Type-1 routes for each VM will be withdrawn one at a time.

  Correct Answer: C