Users report print jobs are not printing off several different network printers. Which of the following should be checked FIRST?
A. Permissions on the printers
B. Local print server on the workstations
C. Spooler service on the print server
D. Netlogon service on the print server
A hardware vendor contacts an administrator about a critical firmware update. Which of the following resources would the administrator MOST likely consult to determine which systems are affected?
A. Warranty documentation
B. Life-cycle documentation
C. Inventory documentation
D. Architecture documentation
After security settings were applied, an application will no longer start on a server. However, users are still able to access the server remotely. Which of the following is MOST likely causing the issue?
A. A necessary service was disabled
B. Port security was tripped
C. The application was uninstalled
D. The DNS settings were changed
Users report they periodically cannot access shares on a file server. The file server has a static IP address of 10.4.0.130. A technician discovers a message about an IP address conflict appearing on the file server. Which of the following should the technician do FIRST to resolve this issue?
A. Create a DHCP reservation
B. Enable DNS options
C. Increase the DHCP scope range
D. Reconfigure the default gateway on the server
An administrator is implementing a RAID 10 array on a new server. Which of the following is the MINIMUM number of disks needed?
A. Two
B. Three
C. Four
D. Five
A systems administrator was tasked with decommissioning a server that contains sensitive data. The systems administrator powered down the server so it was no longer accessible from the network. Two weeks later, during an investigation by security, it is discovered that an employee within the company accessed the server that morning and attempted to access the restricted data. Physical security logs show no one entered the server room. Which of the following hardening techniques was MOST likely neglected on this server?
A. Enabling intrusion detection
B. Stopping unneeded services
C. Installing only required software
D. Disabling WOL
A user was set up with a new computer and is now unable to access a file share on the server. The user was previously able to access the file share from the old computer. The administrator knows the user can access other network resources, and the user's security permissions remain the same. Which of the following is the NEXT logical step for the administrator to troubleshoot this issue?
A. Ping the server from this computer to see if there is a response
B. Log in to another computer as this user and attempt to browse to the share
C. Log in to this computer as a different user and attempt to browse to the share
D. Check security permissions on the file share for this user
A new rack of servers has been installed in a datacenter. A server administrator needs to ensure fault tolerance and redundancy wherever possible. Which of the following would ensure the MOST uptime in the event of a sudden power loss? (Choose two.)
A. Connect the rack PDUs to separate power circuits
B. Connect servers with multiple power supplies to separate power sources
C. Periodically test the UPS batteries to ensure they are fully charged
D. Connect redundant power supplies to the same PDUs
E. Connect all rack PDUs to the UPS battery
F. Connect servers with multiple power supplies to the same higher-amp circuits
A technician is installing multiple servers into a rack. The technician wants to install them so airflow is maximized to keep the servers running according to manufacturer recommendations. Which of the following is the BEST method to install the servers?
A. Stack one on top of the other, leaving no gaps for airflow in between the servers
B. Leave a 1U gap between the servers to allow air to flow between them
C. Spread out the servers over the length of the rack and fill in with other servers later as needed
D. Install the servers alternately facing the front of the rack and the next server facing the back of the rack
Users are unable to send and receive email. A technician verifies services are running, but the server is still not sending and receiving emails. Which of the following commands is BEST to use to find the cause?
A. netstat
B. nslookup
C. ipconfig
D. nbtstat
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only CompTIA exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your SK0-004 exam preparations and CompTIA certification application, do not hesitate to visit our Vcedump.com to find your solutions here.