Exam Details

  • Exam Code
    :VCS-254
  • Exam Name
    :Administration of Veritas Cluster Server 6.1 for UNIX
  • Certification
    :VCS
  • Vendor
    :Veritas
  • Total Questions
    :298 Q&As
  • Last Updated
    :Apr 12, 2025

Veritas VCS VCS-254 Questions & Answers

  • Question 101:

    Which two are default behaviors of Veritas Cluster Server service groups? (Select two.)

    A. Migrate service groups from a system on intentional system shutdown

    B. Start the service groups in lexical order

    C. AutoDisable the service groups on cluster startup

    D. AutoDisable the service groups on a system when all low priority links fail

    E. Start the service groups in the order of the attribute SystemList

  • Question 102:

    A service group has the ManageFaults attribute set to NONE. Which agent entry point is affected by this service group attribute?

    A. online

    B. offline

    C. monitor

    D. clean

  • Question 103:

    What are two major functions of Low Latency Transport (LLT)? (Select two.)

    A. Cluster communications

    B. Traffic distribution

    C. Cluster membership

    D. Heartbeating

    E. Broadcast message

  • Question 104:

    During a test of a NIC resource the VCS engine log indicates that the service group and the IP resource enter the FAULTED state on all systems in the cluster. The NIC resource enters the ONLINE state after the root cause of the fault is corrected. Which default attribute setting allows the service group to attempt to start without manual intervention?

    A. AutoStart

    B. AutoClear

    C. AutoRestart

    D. AutoFailover

  • Question 105:

    Assume that the GroupA service group is online on SystemB.

    Given the following configuration file:

    group GroupA (

    SystemList = { SystemA = 1, SystemB = 2 }

    AutoStartList = { SystemA }

    )

    IP ip0 (

    Device = nic0

    Address = "10.10.10.10"

    NetMask = "255.255.255.0"

    )

    NIC nic0 (

    Device = nic0

    NetworkType = ether

    )

    NIC nic1 (

    Device = nic1

    NetworkType = ether

    )

    ip0 requires nic0

    What happens to the GroupA service group if the network cable connected to nic0 is unplugged on SystemB?

    A. GroupA faults on SystemB and attempts to fail over to SystemA.

    B. GroupA faults on SystemB and attempts to restart on SystemB.

    C. IP traffic is rerouted to the nic1 interface.

    D. The nic0 resource faults and GroupA stays partially online.

  • Question 106:

    Given a resource with the Critical attribute set to its default value, what action does HAD take if that resource faults?

    A. Leaves the service group partially online

    B. Restarts the failed resource

    C. Inititates a failover

    D. Brings only critical resources offline

  • Question 107:

    Which component is responsible for directing that a Veritas Cluster Server (VCS) resource be brought online?

    A. entry point

    B. resource agent

    C. service group

    D. VCS engine

  • Question 108:

    A 2-node Veritas Cluster Server cluster has two dedicated Ethernet heartbeat links and I/O Fencing enabled.

    What will happen if both heartbeat links simultaneously fail?

    A. I/O Fencing takes over as the heartbeat mechanism.

    B. All service groups are frozen on both nodes.

    C. Both nodes panic and reboot into the cluster.

    D. One node panics and the other remains running.

  • Question 109:

    You are adding a system to a running cluster. You have successfully performed these steps on the system that you are adding:

    1.

    Installed, configured, and tested all application resources required

    2.

    Installed VCS

    3.

    Configured and started VCS communications (LLT and GAB)

    What is the next step that you perform?

    A. Update the resource attributes to enable resources to run on the new system

    B. Update the service group attributes to enable groups to run on the new system

    C. Change the cluster attribute for VCS user names to match accounts on the new system

    D. Change the owner of the system attributes so that all cluster systems are the same

  • Question 110:

    How many systems in the cluster can the NotifierMngr run on at one time?

    A. 1

    B. 32

    C. 256

    D. An unlimited number

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Veritas exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your VCS-254 exam preparations and Veritas certification application, do not hesitate to visit our Vcedump.com to find your solutions here.