Cisco CCNP Enterprise 350-401 Questions & Answers

• Question 481:

  Relet lo Ibe exhibit.

  

  An engineer must modify the existing configuration so that R2 can take over as the primary router when serial interface 0/0.1 on R1 goes down.

  Which command must the engineer apply?

  A. R2W standby 100 track 26 decrement 10

  B. R2# standby 100 preempt

  C. R2# track 26 interface SerialWO.1 line-protocol

  D. R2# standby 100 priority 100

  Correct Answer: A

• Question 482:

  An engineer must use flexible NetFlow on a group of switches. To prevent overloading of the flow collector, if the flow is idle for 20 seconds, the flow sample should be exported.

  Which command set should be applied?

  A. flow record recordflow exporter flowexport record recordflow cache timeout active 120 cache timeout inactive 20 cache type immediate

  B. flow monitor monitorflow exporter flowexport record recordflow cache timeout active 120 cache timeout inactive 20 cache type immediate

  C. flow monitor monitorflow exporter recordflow cache timeout active 120 cache timeout inactive 20 cache type permanent

  D. flow record recordflow match ipv6 destination ip-address match ipv6 source ip-address match ipv6 protocol-type view match interface input match interface output match transport destination-port collect counter bytes long

  Correct Answer: B

• Question 483:

  Which solution should be used in a high-density wireless environment to increase bandwidth for each user?

  A. Increase antenna size

  B. Increase the mandatory minimum data rate.

  C. Increase the cell size of each AP.

  D. Increase TX power.

  Correct Answer: B

• Question 484:

  An engineer must construct an access list tot a Cisco Catalyst 9800 Series WLC that will - edirect wireless guest users to a splash page that is hosted on a Cisco ISE server. The Cisco ISE servers are hosted at 10.9.11.141 and 10.1.11.141. Which access list meets the requirements?

  

  A. Option A

  B. Option B

  C. Option C

  D. Option D

  Correct Answer: D

• Question 485:

  A network administrator is designing a new network for a company that has frequent power spikes. The company wants to ensure that employees can the best solution for the administrator to recommend?

  A. Generator

  B. Cold site

  C. Redundant power supplies

  D. Uninterruptible power supply

  Correct Answer: D

• Question 486:

  Which configuration protects the password for the VTY lines against over-the-shoulder attacks?

  A. username admin secret 7 6j809j23kpp43883500N7%e$

  B. service password-encryption

  C. line vty 04 password $25$FpM7182!

  D. line vty 0 15 password $25$FpM71f82!

  Correct Answer: B

• Question 487:

  Which of the following security methods uses physical characteristics of a person to authorize access to a location?

  A. Access control vestibule

  B. Palm scanner

  C. PIN pad

  D. Digital card reader

  E. Photo ID

  Correct Answer: B

• Question 488:

  What is stateful switchover?

  A. mechanism used to prevent routing protocol loops during an RP switchover

  B. mechanism to take control from a failed RP while maintaining connectivity

  C. First Hop Redundancy Protocol for host gateway connectivity

  D. cluster protocol used to facilitate switch faitover

  Correct Answer: B

• Question 489:

  Refer to the exhibit.

  

  What does the response 204 No Content mean for the REST API request?

  A. Interface toopback 100 is not removed from the configuration.

  B. Interface toopback 100 is not found in the configuration.

  C. Interface toopback 100 is removed from the configuration.

  D. The DELETE method is not supported.

  Correct Answer: C

• Question 490:

  Which of the following protocols has a default administrative distance value of 90?

  A. RIP

  B. EIGRP

  C. OSPF

  D. BGP

  Correct Answer: B