Cisco CCNP Data Center 350-601 Questions & Answers

• Question 371:

  When deploying a Cisco HyperFlex edge with a pair of switches, what is the minimum number of interfaces in trunk mode required on each HX node?

  A. 1

  B. 2

  C. 4

  D. 6

  Correct Answer: B

• Question 372:

  What is a benefit of independent resource scaling in Cisco HyperFlex hybrid architecture?

  A. remote booting of converged servers

  B. flexible expansion or compute, caching, and capacity

  C. multivendor converged node hardware support

  D. support for compute nodes with third-party storage

  Correct Answer: B

  Reference: https://www.cisco.com/c/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/solution-overview-c22-744674.html

• Question 373:

  Refer to the exhibit.

  

  During a vPC peer switch reload, there is packet loss between the server and the router. Which action must be taken to prevent this behavior during future reloads?

  A. Set the routed uplink ports of the Cisco Nexus peers as orphans.

  B. Increase the vPC delay restore timer.

  C. Disable vPC ARP synchronize on the vPC peers.

  D. Decrease the OSPF hello and dead interval timers.

  Correct Answer: B

• Question 374:

  Refer to the exhibit.

  

  An engineer logs all occurrences of a configuration being saved. The engineer must generate an additional log message when someone attempts to change the configuration for interface Ethernet 1/1. Which set of commands must be used to meet these requirements?

  

  A. Option A

  B. Option B

  C. Option C

  D. Option D

  Correct Answer: D

• Question 375:

  An engineer must perform a backup operation of the Cisco UCS system. The backup must be transferred to a secure location using UDP and must contain information about VLANs, VSANs, one other policies. Also, the operations team requires the backup file to be in a human-readable format. Which configuration set meets these requirements?

  A. Type: All configuration Protocol: FTP

  B. Type: Full state Protocol: SFTP

  C. Type: Logical configuration Protocol: TFTP

  D. Type: System configuration Protocol: SCP

  Correct Answer: C

• Question 376:

  An engineer must create an EPG called "Test". The configuration request should succeed if the Tenant called "Tenant" and the application profile called "Test" exist. The firewall policy allows only the HTTP connectivity to APIC from the user's computer.

  Which action accomplishes this goal?

  A. Send to APIC payload using HTTP PUT to the Cisco APIC.

  B. Send to APIC payload using HTTP POST to the Cisco APIC.

  C. Send to APIC payload using HTTP POST to the Cisco APIC.

  D. Send to APIC payload using HTTP PUT to the Cisco APIC.

  Correct Answer: B

  Based on the question a tenant named Tenant and an application profile Test should exist.

• Question 377:

  An engineer configures the properties of a cisco UCS cisco integrated Management controller network adapter for a standalone cisco C-Series server. The Fallback Timeout in the vNIC was set to 600. When the failure occurs. The secondary must be used and then fallback when the primary interface becomes available again.

  Which action be taken to meet these requirements?

  A. Set default VLAN on the adapters.

  B. Increase Cos to 6.

  C. Disable VNTAG mode.

  D. Enable Uplink failover.

  Correct Answer: D

• Question 378:

  Refer to the exhibit.

  

  A host with source address 10.10.10.10. sends traffic to multicast group 239.1.1.1. how do the vPC switches forward the multicast traffic?

  A. If multicast traffic is received on Po11 Switch2, the traffic is forwarded out only one Po20.

  B. If multicast traffic is received on Po10 Switch1, the traffic is forwarded out on Po1 and Po20.

  C. If multicast traffic is received on Po11 and Switch2, the traffic is dropped.

  D. If multicast traffic is received on Switch over the vPC peer-link, the traffic is dropped.

  Correct Answer: C

  https://www.cisco.com/c/en/us/support/docs/ip/multicast/214140-multicast-forwarding-in-vpc-based-on-loc.html#anc8

• Question 379:

  An engineer configured an environment that contains the vPC and non-vPC switches. However, it was noticed that the downstream non-vPC switches do not receive the upstream vPC switch peers. Which vPC feature must be implement to ensure that vPC and non-vPC switches receive same STP bridge ID from the upstream vPC switch peers?

  A. System-mac 0123.4567.89ab

  B. Peer-switch

  C. VPC local role-priority 4000

  D. Peer-gateway

  Correct Answer: B

• Question 380:

  Refer to the exhibit.

  

  What is the result of executing this python code?

  A. It backs up Cisco switches to Cisco Prime infrastructure.

  B. It sends the switch configuration to Cisco TAC.

  C. It sends a Cisco device backup to a remote destination.

  D. It schedules a backup on a Cisco switch using EEM.

  Correct Answer: C