HP HP ATP HP2-T26 Questions & Answers

• Question 121:

  A customer purchased a c7000 blade enclosure, fully populated with blade Gen8 servers and Care Pack services. Several days later, the customer purchased an HPZR30W, an HP UPS R8000/3, and two iPDUs.

  Which new items will be covered in the Care Pack services? (Select two.)

  A. both iPDUs if they are mounted in a different rack from the c7000

  B. the ZR30W (30 inch) monitor put on top of a rack.

  C. both iPDUs if they are mounted in the smae rack as the c7000

  D. the UPS R8000/3 if it is mounted in another rack

  E. the UPS R8000/3 if it is in the same rack as the c7000

  Correct Answer: AC

• Question 122:

  You replace a fully buffered DIMM and want to verify it by running the ROM-Based Memory Test. Where can you access this test?

  A. HP System Management Home Page

  B. Insight Diagnostics Offline Edition

  C. ROM-Based Setup Utility (RBSU)

  D. HP Insight Diagnostics Online Edition

  Correct Answer: B

• Question 123:

  What is a DDR3 Memory population rule to follow for Gen8 servers?

  A. If only one processor is installed in a two processor system, only half of the DIMM slots are available.

  B. DIMMs of different voltages cannot be mixed in the same bank.

  C. DIMMs of different speed grades can be mixed.

  D. UDIMMs, RDIMMs, or LRDIMMs can be mixed.

  Correct Answer: A

• Question 124:

  A customer wants to verify that all the memory DIMMs in an HP Gen 8 server are genuine HP What will provide this information?

  A. Windows Event Viewer

  B. ROM based setup utility (RBSU)

  C. SmartMemory

  D. iLO Event Log

  Correct Answer: C

• Question 125:

  Refer to the exhibit below.

  

  As shown in the exhibit, four BL460c G6 Server Blades are installed in a c7000 enclosure. What is the maximum number of BL680 Server Blades that can be added to this enclosure without powering off any blade?

  A. 4

  B. 5

  C. 6

  D. 12

  Correct Answer: D

• Question 126:

  Which connectivity type is supported to access Systems Management Architecture for the Server Hardware (SMASH) Command Line Protocol? (Select three.)

  A. serial

  B. ftp

  C. rcp

  D. telnet

  E. ssl

  F. ssh

  Correct Answer: ADF

• Question 127:

  What is the maximum number of SB1760c Tape Blades that can be installed in a c7000 blade enclosure?

  A. 16

  B. 8

  C. 4

  D. 2

  Correct Answer: B

• Question 128:

  Why should an electrostatic discharge (ESD) wrist strap be used when replacing parts such as memory DIMMs?

  A. ESD protection is built into the equipment, so an ESC wrist strap is not needed.

  B. A 48 V DC PSU will contribute to higher static electricity.

  C. It prevents the part from being damaged by static electricity.

  D. A current of more than 75 mlcan kill someone.

  Correct Answer: C

• Question 129:

  When using the HP Online Diagnostics Utility on a BL460c server, which component information cannot be tested using the online tool?

  A. total memory

  B. video controllers

  C. network cards

  D. array controllers

  Correct Answer: A

• Question 130:

  Which HP tools should be used to determine that an SSD drive has degraded due to a high number of write operations? (Select three.)

  A. Array Configuration Utility

  B. Array Diagnostic Utility

  C. Option ROM Configuration for Arrays

  D. SmartSSD Wear Utility

  E. ROM Based Setup utility

  Correct Answer: ABD