NetApp NetApp Certifications NS0-502 Questions & Answers

• Question 11:

  Which option needs to be set on a volume to guarantee that it cannot be affected by other volumes?

  A. None

  B. Volume

  C. Space Reserved

  D. Reservation Enabled

  Correct Answer: B

• Question 12:

  Which option needs to be set on a LUN to guarantee that it cannot be affected by other LUNs in the volume?

  A. Volume Guarantee

  B. Volume Space Reserved

  C. LUN Reservation Disabled

  D. LUN Reservation Enabled

  Correct Answer: D

• Question 13:

  At which storage object level is deduplication enabled?

  A. Aggregate

  B. Volume

  C. Qtree

  D. LUN

  Correct Answer: B

• Question 14:

  Which commands allow you to enable NetApp deduplication and verify space savings?

  A. sis on , sis start , df s

  B. asis on , asis start , df s

  C. sis on , sis start , df r

  D. sis on, sis start, df p

  Correct Answer: A

• Question 15:

  You are about to replace a failed Brocade Fibre Channel switch.

  Which three steps do you take prior to connecting the switch in the SAN? (Choose three.)

  A. Force the new switch to be the principle switch.

  B. Change the domain ID of the replacement switch to the domain ID of the failed switch.

  C. Clear all zoning configurations on the replacement switch.

  D. Change the core PID format of the replacement switch to the core PID format of the failed switch.

  E. Preload the zoning information from the fabric onto the new switch.

  Correct Answer: BCD

• Question 16:

  When running diagnostic tests after an initial installation of a NetApp FAS3000 storage system, which command is used to run a comprehensive set of diagnostic tests on the entire system?

  A. all

  B. comprehensive

  C. full

  D. stress

  Correct Answer: A

• Question 17:

  Which native GUI switch tool is used to manage Cisco MDS-Series switches and directors?

  A. Operations Manager

  B. Fabric Manager

  C. Web Tools

  D. Data Fabric Manager

  Correct Answer: B

• Question 18:

  Which configuration for primary block (FC and iSCSI) data does NetApp best practices recommend?(Choose two.)

  A. single controller single shelf

  B. single controller multiple shelves

  C. dual controller single shelf

  D. dual controller multiple shelves

  Correct Answer: CD

• Question 19:

  After completing the configuration of a new Brocade Fibre Channel switch, which command do you use to verify your configuration?

  A. switchshow

  B. show config

  C. configshow

  D. cfgshow

  Correct Answer: C

• Question 20:

  When booting your NetApp storage system for the first time the system fails to boot.

  What should you do first to address this problem?

  A. You turn off your storage system and disk shelves, and then turn on the disk shelves. You then check the quick reference card that came with the disk shelf for information about LED responses.

  B. You re-download the boot image to the compact flash card, then reboot the system.

  C. You look for a description of the problem on the LCD and console. You then follow the instructions, if provided, on the LCD and console.

  D. You verify disk shelf compatibility and check the disk shelf IDs to verify that the disk shelf 1 (for DS14 series) must be connected to your system.

  Correct Answer: C