Symantec Symantec Certifications ST0-250 Questions & Answers

• Question 21:

  An administrator wants to ensure high performance and failover access between the LDAP servers and Symantec Messaging Gateway 10.5. Which configuration mode will help ensure this?

  A. configure DNS to accept dynamic updates

  B. setup multiple LDAP sources

  C. round robin DNS

  D. scanner load balancing

  Correct Answer: C

• Question 22:

  Which directory data source function must be enabled to help prevent a directory harvest attack?

  A. Active Directory connector

  B. Dynamic Data Sourcing

  C. LDAP authentication

  D. Recipient validation

  Correct Answer: D

• Question 23:

  An organization would like to participate in the Symantec Probe Network without having to manually create decoy email accounts. The organization wants to make sure that the addresses that participate in the Symantec Probe Network are currently receiving email. Which directory data source function should be enabled to help in this situation?

  A. recipient validation

  B. address resolution

  C. SMTP authentication

  D. LDAP routing

  Correct Answer: A

• Question 24:

  How does Symantec DLP communicate with Symantec Messaging Gateway (SMG) to indicate what type of incident (if any) is related to a given message?

  A. Symantec DLP uses the ICAP protocol to indicate if a message is clean,or if it violated any defined policies.

  B. Symantec DLP will add information into the message that can be interpreted by SMG and then send it to SMG via SMTP.

  C. Symantec DLP will quarantine messages that violate established policies,blocking it from SMG.

  D. Symantec DLP will use TLS to send a notification message to the SMG server for any content violations.

  Correct Answer: B

• Question 25:

  What are two functions of the Control Center? (Select two.)

  A. It provides message management services.

  B. It downloads spam definitions.

  C. It hosts Spam Quarantine.

  D. It downloads virus definitions.

  E. It runs filters.

  Correct Answer: AC

• Question 26:

  During which phase of outbound message flow does Symantec Messaging Gateway 10.5 determine whether the number of recipients exceeds the good number of recipients per message?

  A. message routing

  B. message delivery

  C. outbound SMTP session

  D. outbound SMTP connection

  Correct Answer: C

• Question 27:

  How should an administrator stop inbound mail using the command line interface (CLI)?

  A. use mta-control

  B. use mta-stop

  C. use mail-control

  D. use mail-stop

  Correct Answer: A

• Question 28:

  How can an administrator view log data in real time?

  A. in the UI select Reports -> view logs

  B. from the command line interface (CLI) run the watchlog -l command

  C. from the command line interface (CLI) run the tail -f command

  D. from the command line interface (CLI) run the monitor -f command

  Correct Answer: C

• Question 29:

  What is the function of a sender authentication scheme?

  A. to check the IP reputation of a sending MTA at connection time

  B. to verify that the sending MTA is authorized to send mail for a given domain

  C. to enforce two-factor authentication between sending and receiving MTAs

  D. to ensure that senders using content encryption can bypass spam scanning

  Correct Answer: B

• Question 30:

  With Fastpass enabled, which two verdicts may be excluded for messages with a pass? (Select two.)

  A. Spam

  B. Suspected Spam

  C. Virus

  D. Suspected Virus

  E. Compliance

  Correct Answer: AB