Exam Details

  • Exam Code
    :ISS-003
  • Exam Name
    :Intel Server Specialist Certification Exam
  • Certification
    :CompTIA Intel Server Specialist
  • Vendor
    :CompTIA
  • Total Questions
    :186 Q&As
  • Last Updated
    :Mar 25, 2025

CompTIA CompTIA Intel Server Specialist ISS-003 Questions & Answers

  • Question 151:

    Your customer is close to approving a sale of 35 server systems which require maximum memory configurations. While looking at the Bill of Materials you are asked what (if any) are the benefits of using LR-DIMM over RDIMM. And if there are none to go with RDIMMS. How would you answer him?

    A. LR-DIMM's speed is higher

    B. LR-RDIMM's support ECC

    C. More memory can be installed, since LR-DIMM supports rank multiplication

    D. Mirroring/Sparing memory mode can be set up using LR-DIMMs

    E. LR-DIMM's have a dedicated memory controller, which offoads CPU cycles

  • Question 152:

    What is the maximum number of hard drives supported with RSTe provided the correct number of ports is available on the motherboard?

    A. 4

    B. 8

    C. 32

    D. 64

  • Question 153:

    Your customer calls to say that an Intel Server system R1208WT2GS is showing several entries in the system event log that PSU redundancy was lost. How would you advise your customer from the following list?

    A. Only one CPU is installed

    B. ThePSUsare pluggedinto differentphases

    C. Redundancy should be enabled in BIOS

    D. An unsupported UPS is being used

    E. The PSUs have different wattages

  • Question 154:

    Which of the following documents details the BIOS and BMC architecture for a particular generation of Intel Server boards?

    A. TPS

    B. PCN

    C. GPS

    D. EPS

    E. ECCN

  • Question 155:

    During a RAID "Deep-Dive" training event that you have organized as the Intel Server Specialist, you have been asked how to increase the speed of HWRAID. How would you answer that question from the following list? (Select ALL that apply).

    A. "Write Through" should be enabled.

    B. The battery should be removed.

    C. "No Read Ahead" should be enabled.

    D. "Always Read Ahead" should be enabled.

    E. "Always Write Back" should be enabled.

  • Question 156:

    Your customer reports that since changing the memory speed settings in Bios Setup on an Intel Server Board S2600CW2 in chassis P4304XXMFEN2 now will not start and 3 beeps can be heard. How would you advise your customer to proceed?

    A. Clear CMOS by jumper

    B. Update the firmware with BIOS recovery jumper enabled

    C. Reset the BMC via jumper

    D. Start the system with one DIMM installed

    E. Remove A/C power from the server for 2 minutes then switch on

  • Question 157:

    A customer has installed the Intel Server board S2600CW into a third party chassis. Since powering it on the cooling fans are running continuously at maximum RPM and the sensor readings are incorrect. Which of the following is the FIRST step in troubleshooting the problem?

    A. Clear CMOS

    B. Update the BIOS, BMC and FRUSDR

    C. Update the SDR with "other chassis" option

    D. Update the FRUSDR

    E. Reset the BMC

  • Question 158:

    Your customer calls you as the Intel Server Specialist with a problem; is it possible to install Microsoft* Windows* Server 2012 R2 on a disk with capacity over 2 TB?

    A. Yes, but you need to convert the disk to GPT and use UEFI installation

    B. No, OS policy does not allow the use of large partitions for the system disk

    C. Yes, but you need to create a partition with size under 2TB

    D. Yes, with the x64 version of OS

    E. Yes, the installation process is the usual one

  • Question 159:

    A customer configuration based on the Intel Server System R2224WTTYS has an HBA and Fibre Channel adapters installed and ESRT2 enabled. The problem being reported is that the system hangs on boot. Which of the following could be used to resolve the problem? (Select ALL that apply).

    A. The system must have more than 32GB RAM

    B. The HBA may only be used in the second riser slot

    C. Unused OpROMs should be disabled in the BIOS configuration

    D. MMIO should be set to 512GB

    E. ESRT2 must be the first boot device

    F. Enable EFI optimized boot in the BIOS

  • Question 160:

    As an Intel Server Specialist you have been asked by one of your biggest server resellers for help in planning and configuring their new line of servers. One of their questions relates to graphics; in which of the following Intel Server boards can Intel HD graphics be used. How would you answer from the list below? (Select ALL that apply).

    A. S1200BTL

    B. S1200V3RPL

    C. S1600?P

    D. S1200V3RPM

    E. S1400FP

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only CompTIA exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your ISS-003 exam preparations and CompTIA certification application, do not hesitate to visit our Vcedump.com to find your solutions here.