1. Home
  2. Cisco
  3. 300-615

Troubleshooting Cisco Data Center Infrastructure (DCIT)

Exam Details

  • Exam Code
    :300-615
  • Exam Name
    :Troubleshooting Cisco Data Center Infrastructure (DCIT)
  • Certification
    :CCNP Data Center
  • Vendor
    :Cisco
  • Total Questions
    :217 Q&As
  • Last Updated
    :Mar 24, 2025

Cisco CCNP Data Center 300-615 Questions & Answers

  • Question 171:

    A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

    A. Configure the NVE interfaces to be Up on both switches.

    B. Set a different distributed gateway virtual MAC address.

    C. Set a different secondary IP addresses on NVE source-interface.

    D. Configure the same VNI to multicast group maping.

    E. Set a different primary IP addresses on NVE source-interface.

  • Question 172:

    A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?

    A. Use route-map to advertise this MAC statically and redistribute with ISIS.

    B. Unknown unicast flooding is not allowed.

    C. Use the otv flood mac <> command to selectively flood traffic for a given MAC.

    D. Use the otv isis bfd <> command to configure BFD protocol.

  • Question 173:

    Refer to the exhibit.

    After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.)

    A. Configure the local vPC role priority to have a lower value than Switch-A.

    B. Configure the local vPC role priority to have a higher value than Switch-A.

    C. Disable and then re-enable the vPC peer-keepalive link.

    D. Configure the local vPC role priority to have the same value as Switch-A.

    E. Disable and then re-enable the vPC peer link.

  • Question 174:

    Refer to the exhibit.

    An engineer fails to implement VRRP on a Cisco Nexus 7000 Series Switch. Which action resolves the issue?

    A. Activate the VRRP license.

    B. Configure the VRRP instance globally.

    C. Enable the VRRP feature.

    D. Set the VRRP group number.

  • Question 175:

    Refer to the exhibit.

    The servers experience intermittent connectivity issues in VLAN 10. Which action resolves the issue?

    A. Configure the same HSRP group on the peer switches.

    B. Enable HSRP hellos between the peer switches.

    C. Disable the preempt feature on one of the peer switches.

    D. Change the virtual IP address on one of the peer switches.

  • Question 176:

    Refer to the exhibit.

    The network administrator must use a scheduler to perform configuration backups every night. After completing the configuration, the administrator discovers that configuration backups occur at 05:15 in the morning instead of at 02:00. Which action resolves the issue?

    A. Activate the scheduler manually at 02:00 local time.

    B. Create a periodic scheduler that runs every 24 hours.

    C. Implement the switch clock to match the local time.

    D. Configure the scheduler within the CONFIG_BACKUP job.

  • Question 177:

    Refer to the exhibit.

    A switch fails to join the storage area network fabric in VSAN 6 where the fabric binding is enabled. Which configuration set resolves the issue?

    A. Option A

    B. Option B

    C. Option C

    D. Option D

  • Question 178:

    Refer to the exhibit.

    A client is reporting packet drops destined for the call recording server connected to Cisco Nexus 9000 Series Switch. Which action resolves the issue?

    A. Increase the MTU size on the Ethernet interface connected to the recording server.

    B. Increase the TCAM hardware rate limit.

    C. Increase the TCAM resources on the switch.

    D. Increase the rate limit on the Ethernet interface connected to the recording server.

  • Question 179:

    Refer to the exhibit.

    The NetOevOps team is using REST API calls to automate the Cisco APIC monitoring. Which action resolves the issue?

    A. Remove the attributes keyword from the message data.

    B. Change the API request method to POST.

    C. Modify the URI to http://apic1/api/aaaLogin.xml.

    D. Use "double quotes" between each word in the message area.

  • Question 180:

    Refer to the exhibit.

    A network engineer is troubleshooting an issue where a user reports that they failed to reach the business application server while N9K-1 is down. Which action resolves the issue?

    A. Change the priority value of the N9K-2 switch to 120.

    B. Remove the peer-switch feature from the N9K-2 switch.

    C. Remove the VPC configuration from the application server interface configuration.

    D. Configure the peer-gateway feature on both Cisco Nexus switches.

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 300-615 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.