HP HP Certifications HPE6-A41 Questions & Answers

• Question 51:

  A network administrator wants to form a cluster with several Aruba Instant APs. What is required to achieve this goal?

  A. All APs must be pre-configured with WLANs with the same SSID.

  B. All APs must be in the same regulatory domain.

  C. All APs must operate on the same radio channel.

  D. All APs must be the same model.

  Correct Answer: B

• Question 52:

  Refer to the exhibits.

  Exhibit 1 Exhibit 2

  

  

  A network uses RSTP, as shown in the exhibits. The network administrator wants switches to use the link that connects to Core-2 to forward some of the traffic. The administrator enters these commands on every switch shown in the exhibit:

  

  The administrator then discovers that the links to Core-2 still did not forward any traffic. What should the administrator do to enable these links to carry traffic?

  A. Activate the MSTP region configuration on all switches.

  B. Lower the port cost on the links that connect to Core-2 on the access layer switches.

  C. Configure Core-2 with spanning tree priority 0 in instance 2.

  D. Change the spanning tree mode to MSTP on all switches.

  Correct Answer: B

• Question 53:

  Member1 is the commander of a Virtual Switching Framework (VSF) fabric. A power distribution causes member 1 to go down. Now the network administrator wants to rejoin member1 to the VSF fabric and make member1 the commander again.

  What should the administrator do?

  A. Boot member1 and allow it to rejoin to the VSF fabric. Then reboot member2.

  B. Boot member1 and allow it to rejoin the VSF fabric.

  C. Disconnect member1 from member2 before booting member1.

  D. Configure member2 with VSF priority0. Then boot member1 and allow it to rejoin the VSF fabric.

  Correct Answer: D

• Question 54:

  A network administrator wants to see the VLANs supported on one ArubaOS switch interface and if those VLANs have tagged or untagged assignments. What should the administrator do to find this information?

  A. View the MAC forwarding table for the interface and VLAN with the show mac-address command.

  B. Use the detail option with the show vlans port command.

  C. Use the local-device option with the show lldp info command.

  D. View the interface with the show interface command.

  Correct Answer: B

• Question 55:

  A network administrator wants to disable physical interfaces 13-24 on an ArubaOS switch. How can the administrator do this?

  A. Assign the range of interfaces to a VLAN. Then, disable the VLAN.

  B. Create a named range for interfaces 13-24. Then, disable the named range.

  C. Create a named port group for interfaces 13-24. Then, disable the named port group.

  D. Use the interface disabl command. Specify 13-24 for the ID.

  Correct Answer: D

• Question 56:

  Which technology can provide automated network optimization for unified communication applications such as Skype for Business?

  A. Software-defined Networking (SDN)

  B. Zero Touch Provisioning (ZTP)

  C. Simple Network Management Protocol (SNMP)

  D. Virtual Switching Framework (VSF)

  Correct Answer: A

• Question 57:

  A network administrator needs to set up a static LACP link aggregation. How should the administrator configure the VLAN settings for the link aggregation?

  A. Configure the VLANs on the physical interface with the lowest port ID before link aggregation setup.

  B. Configure the VLANs on both physical interfaces after link aggregation setup.

  C. Configure the VLANs on the link aggregation interface after the link aggregation setup.

  D. Configure the VLANs on both physical interfaces before link aggregation setup.

  Correct Answer: A

• Question 58:

  A network administrator enters this command on an ArubaOS switch with IP routing enabled:

  

  This is the only IP route to 0.0.0.0/0 on the switch.

  What is the effect?

  A. The switch uses this route to route all traffic from 10.1.1.1.

  B. The switch uses this route for all traffic unless the traffic matches a route with a lower cost than 10.

  C. The switch uses this route for all traffic unless the traffic matches a route with a lower administrative distance than 10.

  D. The switch uses this route for all traffic that does not match a specific route in its routing table.

  Correct Answer: D

• Question 59:

  A company has two ArubaOS switches, Switch1 and Switch2. Switch1 will be the commander for a new Virtual Switching Framework (VSF) fabric. Switch2 is a new switch that will be the standby member. The network administrator wants to configure the proper settings on the standby member interface before the standby member joins the fabric.

  What should the administrator do before the switches are joined in the VSF fabric?

  A. Configure the interface settings on Switch2. Then enable VSF on Switch2.

  B. Enable VSF on Switch2. Then configure the interface settings on Switch2.

  C. Provision member2 on Switch1. Then configure the member2 interface settings on Switch1.

  D. Provision member2 on Switch1 and member1 on Switch2. Then configure the member2 interface settings on Switch2.

  Correct Answer: D

• Question 60:

  Refer to the exhibit.

  

  A network administrator wants to set up a link aggregation between two switches, as shown in the exhibit. The link aggregation must meet these requirements:

  Protects against misconfiguration Can be configured with VLANs and other settings Which type of link aggregation should the administrator create?

  A. dynamic LACP

  B. static LACP

  C. manual (trunk)

  D. distributed (trunk)

  Correct Answer: B